The BigClown IoT Kit has been designed the way to allow connection of multiple power sources.

For example, this allows the Core Module to be powered from a USB cable and also have batteries inserted in the Battery Module at the same time. BigClown automatically solves the problem selecting the appropriate power sources.

What does it mean? For example, when an external power supply (adapter or USB) is connected, the battery is disconnected and discharged. It is also possible to have multiple external sources connected at the same time - for example, the adapter plugged into the Power Module and the USB cable in the Core Module.

How It Works

The BigClown header has two signals for system power distribution:

  1. VDD - Positive supply rail either 3.1 V when powering from batteries or 3.3 V from the external power supply

  2. GND - Ground (negative rail)

The module that is able to deliver power in the system is called the energizer. The energy is supplied either using an external power supply, or using batteries. In both cases, an energizer contains the electronics circuit for intelligent power management.

This additional electronics circuit controls (or is controlled by) two auxiliary signals on the BigClown header:

  1. Signal BAT_OFF

    This signal disconnects the batteries and prevents their discharging when other power source is available and the batteries are not needed.

  2. Signal VDD_OFF

    This signal is physically split into two parts:

    • Signal VDD_OFF_IN

      This signal is on the bottom side of the module (the side with the pins) and it disconnects the power supply output of the given module.

    • Signal VDD_OFF_OUT

      This signal is on the top side of the module (the side with the sockets) and it is chained to the VDD_OFF_IN signal of the module above the given one.


This is the example of the eletronics circuit of the battery energizer:

Example schematic circuit of the battery energizer

This is the example of the eletronics circuit of the energizer powered from an external power supply:

Example schematic circuit of the energizer powered from the external power source

Whether it is a battery power or a external power source, the two P-channel MOSFETs are always on the output of the power supply in the so-called back-to-back configuration. This guarantees complete power supply disconnect and no backflow current is possible when the power supply is not operating.

Chapters in this document:
Edit this page

We will inspire you!

You will get regularly our Clownsletter with real projects from other Makers. Do not miss it!

By sign up you will know how even you can inspire others and get €100 discount coupon!